Whatever the infrastructure Cabling System you are going to have and how will you decide? Which cable do you prefer CAT6 1000ft Plenum Network Ethernet Cables or CAT6A Plenum Ethernet Cable?
These queries have quite simpler
answers than your expectations. Firstly, you will have to explore which current
applications are being used? Which future applications are in use in your
organization? What would be the growth level of your network in the next five
years with reference to data transmission and number of users? What would be
the expected lifespan of your organization’s building? Whether it will be in a
working condition in the next 5, 10, 20 or 25 years? What are the cabling
standards now and where they are heading? What is the expected cost? What is
your budget? What will be the cost of reinstalling a new network now and what
will be in the coming years to handle future speeds?
You have to consider many factors
while deciding which cabling network is best to install. CAT6A Plenum Ethernet Network Cable performance is best till now so
it could be a wise choice for installing a cabling network for future proof
against enhanced networking speeds. CAT-6A is available in the market in two
options: shielded or unshielded solution with each option having its own
benefits, place and value. Moreover, it is backwards compatible with its
ancestors such as Cat6A Plenum Pure Copper 750MHz 23 AWG 1000ft UTP Networking Cable and
CAT-5e because of access use of the RJ45 connector. In short, CAT-6A can be
described as a cost effective solution for existing and emerging applications.
This is because it has higher bandwidth and 10Gbps network speeds even at a
distance of more than 100 meters.
Besides, CAT6A Plenum Ethernet 1000ft Network Cable and structured cabling
products have additional uses for applications than voice and data. These
include building automation, CCTV, access control and many more. Thus, the
integration of all these applications into a single cabling infrastructure has
another benefit. Designers need to consider the necessity of running minimum
two Category 6A cables at every access point.
This method offers backup,
redundant communications and PoE power from two distinct backhaul sources and
enables the AP to keep working even in case a switch or PoE source goes down.
Another important thing to consider is the availability of dual port access
points. Nowadays, many cabling companies have been or are testing 100 watts of
PoE power that will require Cat6A Plenum Pure Copper 750MHz 23 AWG1000ft UTP Networking Cable wiring because of the heat that travels
down in the wire. On the other hand, next generation power devices will need
enhanced bandwidth than Gigabit Ethernet as well as more delivered power. These
power devices include wireless access points and large-display HDTVs etc. Hence,
designers should design networks by keeping all these future demands in their
mind.
If you still have any query
regarding the selection of right cabling infrastructure or you want someone's
assistance to understand it more clearly, contact Account Executive at
www.taylored.com right now. Our two BICSI RCDD staff will assist you in
designing structured cabling solutions of your choice.
Comments
Post a Comment